TSRE not loading some signals

[SCrail]

Hi everyone, here's my issue:
I am trying to add signals to a route I am working on, using an existing set of signals (86 of them). However, when I go into the "Signals" folder in TSRE (any version), only 15 signals show up (which happen to be the first 15 signal shapes referenced in sigcfg).
I suspected the was an issue in the sigcfg file, but when I tested some routes which use this set, they worked fine in OR. However, when I opened these in TSRE, depending on the version the affected signals would either not show up (v0.8.005y), or would crash the editor when I selected them (v0.7).
Thank you in advance for your help!

tsre-log-20260117-2157.txt
sigcfg and sigscr.zip

[SCrail]

After more testing, I have found the issue! The culprit was the 15th (and last) signal loaded by TSRE, which had a syntax error (on line 11616), which weirdly was never picked up by either OR or TSRE (although the latter was then unable to load all following signals because of it).

[eric]

Glad you found it. I've been looking thru the file and didn't see an error but now with the l8ne reference, it gives me an opportunity to evaluate it and log it in the next version of TSRE.

Sent from my SM-S911U using Tapatalk