Subtile disappearing in TSRE

[IndianRailways1601]

I'm fairly certain I knew how to fix this before. I'm clueless now.

I selected a sub tile, right clicked and chose 'toggle draw' after which the sub tile disappeared leaving a white patch. How do I select the sub tile so I can toggle it off again? I can select the sub tiles adjacent to it, but not the one in question.

In other words, how can I revert 'toggle draw' from a sub tile? Especially since the sub tile cannot be selected after toggle draw is enabled.

Edit: Adding a picture

[Vince]

Hello Swadesh,

I believe you should click select the two subtiles on either side of the problem tile while holding the [SHIFT] key pressed.
This in effect selects all three sub-tiles. Then you may toggle all draw on or off.
This is rather a hazy memory from when I was repairing the PRR-East route.
There is a post of mine at ELVAS Tower in the Contributed Software section where I discussed this exact problem with GOKU and
was provided with the answer.

regards,
Edit Add: Well! I found the ELVAS Tower post I referenced above:
>===> http://www.elvastower.com/forums/ind..._1#entry231961
cheers!
v

[IndianRailways1601]

Thank you so much! I've fixed it now

[muskokaandtahoe]

FWIW I just found this problem myself. Following the instructions posted here did not fix it but selecting all 4 adjacent tiles and then hitting Draw did work. The Draw button is found in the middle of the Properties window which is usually over on the left side of your screen.