Not all .inc files load

[muskokaandtahoe]

A typical .wag file of mine (embedded blanks are NOT in my file but are here after doing a copy/paste; WTF?):

SIMISA@@@@@@@@@@JINX0D0t______

Wagon ( XM_CNJ_20375_MT
WagonShape ( CNJ_USRA_20375.s )
FreightAnim ( usra_ss_50xm_parts.s 1 1 1 )
Include ( "..\\Common.Inc\\Models\\Tim_Muir\\USRA_SS_Box car\ \XM_USRA_SS_Empty_Car.inc" )
Include ( "..\\Common.inc\\Fleet\\Approved\\Std_Type_D_C oupl er_Generic_Draft_Gear.inc" )
Include ( "..\\Common.inc\\Fleet\\Approved\\Single_Pipe_ AB_B rakes.inc" )
Include ( "..\\Common.inc\\Fleet\\Approved\\Std_Cast_Iro n_Br akeshoe_Friction.inc" )
Sound ( "genfreightwag2.sms" )
Name ( "XM 40' CNJ USRA_SS 20375 MT" )
)

The first Include statement loads but not any of those that follow it.



=======================================

Here is a .inc file (not part of the above .wag). Note the value of Mass90 (in bold):

Comment ( XM_USRA_DS_Animal_feed_LD.inc )

comment ( "Part 2A and 2B are parameters based on presence or absence of a load. " )
comment ( "Parameters for an empty car belong in an Empty_Car.inc file." )
comment ( "Parameters for a loaded car belong in a Lading Name Loads.inc file." )

comment ( "Part 2A - parameters based on presence or absence of a load." )
Mass ( 51.9738t-us )
CentreOfGravity ( 0m 1.9m 0m )
DerailRailForce ( 117.8765kN )
DerailBufferForce ( 392.2992kN )
ORTSDavis_A ( 183.5659lbf )
ORTSDavis_B ( 2.3388lbf/mph )
ORTSDavis_C ( 0.0613lbf/mph^2 )


comment ( "Part 2B - Unsupported parameters based on presence or absence of a load." )
LadingName ( "Animal feed" )
LadingWeight ( 30.1088t-us )


Here is what I see in the Consist editor.

The value of Mass() as seen below is data from the first .inc file. The .inc I posted, above is the contents of the second .inc file. You can see that value of Mass(), brakes, and couplers below, only the first .inc file was read.


gn.jpg

[eric]

I'll look, but it's also possible the other values are being read but only the first are being applied.