Signal problem/ TSRE? / ORTS?/ Me?

[dlfrenchmd]

The transition to Windows 11 has been laborious and aggravating for me. But I am old. Young ‘uns be patient, please.
This problem existed before the transition, and has persisted. My route is Rock Island/ ATSF around Colorado Springs. ATSF is the north/ south main and the Rock goes from a middle wye in C. Springs east to Limon and beyond.
Attachment 1 is an overall view with ATT2 a closeup of the ATSF N-S main and the RI wye in the middle.
The problem is as follows:

1. Am using Travis Ebner’s signals: tem_atsf_signals_1, tem_ri-mp_signals_1
2. Signaling problem exists on both sets. Also if I use only 1 set (either one).
3. Problem is with all diverging routes’ signals at Left or Right Switch (any type). I use a two head absolute. It shows green over red on approach, but stays green over red when switch is changed to diverging route. Close inspection discloses a flicker in the green head on switch change, but no color change. All switches in both sets for the entire route do this.
4. I had no problems placing these signals on previous routes. Using TSRE, I placed the signals on Travis’s Signal Test routes and they work fine.
5. I cut out a piece of track on the ATSF parallel N-S main with no effect.

Not sure what is happening. Maybe the track plan loops too much and is faulty. Not sure.
Appreciate your input.
Dan

[eric]

Try putting two interval signals between each of the individual wyes. That is how I've had to do turning loops.

Sent from my SM-S911U using Tapatalk

[landnrailroader]

Easy for me to be patient. At almost 87, I guess I qualify as old?

Jerry

[dlfrenchmd]

You got me beat by a decade, Jerry! Thanks, Eric, I will give it a try.

[dlfrenchmd]

I placed an AUTO signal each direction at areas indicated by red arrows. No change.
Dan