Problems with signal positions

[213 001-1]

Dear railway freinds!

On the German Railroads GR 5 Rollbahn 1963 route I have the problem that there are always sections on the route where the train is normally allowed to travel at the permitted line speed, but instead the signals show slow speed. The route leads straight ahead and does not branch off over switches. This phenomenon occurs at entry signals, but also on the open road. There are even signals that show stop even though the route is clear.

Does anyone of you know the problem and know a solution?

I thank you in advance for your answers.

[213 001-1]

Based on the manual point 11.14.2. Location of OR-specific sigcfg and sigscr files, i created a folder called "OpenRails" and copied the files sigscr.dat and sigcfg.dat from the route into that folder.

The problem with the permanent stop showing signals is solved. But the problem with slow speed showing signals is only solved in bridge areas. In railway stations there is still the problem, that You only can pass them with a maximum speed of 30 km/h.

Open Rails 2026-02-18 08-48-59.jpg Open Rails 2026-02-18 08-58-11.jpg

[213 001-1]

What i also found out is, that this problem with the slow speed signals is only at the routes of the producer "German Railroads", but not at the routes of the producers "Pro Train". That's strange because it means, that there must be something different between the signalscripts of both producers.