ORNYMG 162.2/Borislav's ES44AC Cab/EOT TESTING & ARMING

[qballbandit]

Hello,
Last year, I added into Borislav's ES44AC cab the EOT functionality available for OR. I had it working perfectly in older MG 143* versions.
Now in 162.2, after selecting my EOT window on the cab display screen, the EOT TEST or EOT ARM no longer responds after I add an EOT device to my train. I can see it all respond correctly in the Train Info window (F5); it will display testing, arming, and armed successfully - just not in the cabs right display screen. It continuously reads "Failed" and "Disarmed".
Looking for those who use this set up to respond with their results and/or comments.

Screenshot shows just after selecting the "EOT Test" button on the display screen. It should show as "Testing", or whatever it normally used to say.

Thanks very much!

Neil

eotfailmg.jpg

[csantucci]

Hi Neil,
can you try applying attached patch to ORNYMG 163?
Orts.Simulation.zip

[qballbandit]

Yes sir. I will do so and report back first chance I have to run and look at results. Thank you very much for responding, I appreciate it!

[qballbandit]

Hi Carlo,

First - I downloaded 163 and installed, then added your files and the EOT TEST/ARM/DISARM all work. Thank you!!!!!

Second - 2 observations when working with 163 for a short time: 1) when I tried to use the OpenRails64 to open the GUI, it failed because file ICSharpCode.SharpZipLib.dll was not found. I copied it from 162.2, and then it worked fine. 2) I installed Reshade, but it does not seem to be recognized when starting activities. I tried removing and installing again with no luck.

Any ideas??

[csantucci]

About point 2, please apply following patch to ORNYMG163

[qballbandit]

Yes, Carlo - that did it! I appreciate your assistance, kind sir