Help integrating new rail for OR

[vline45]

Just to clarify, I mentioned this earlier and don't think it was addressed,

"One question, if I've built the new track piece higher on some ballast, will switching with the Xtrack piece raise the height as well? Will a train sit at the right height of the new piece?"

How are heights of substituted track pieces managed?

Thanks.

[eric]

Depends on where the axis is. Substitution won't raise/lower the track.

In general, if your track is 3D rail and ties, you'll need to make sure the axis is set so that the wheels on the trains don't float or dig into the 3D rails. On my fake Scalerail sections the railhead is .32m above the axis. I could be totally wrong in what it's supposed to be, and honestly, it's been way to long since I've done it, having relied on Scalerail and Dynatrax to generate my track pieces.