Cajon Pass grade problem

[mg123]

I drove default eastbound stack train activity for Cajon pass 4.0.
There was no problem with MSTS.
But problem with Open rails.
Train could not negotiate eastbound Cajon pass grade.
So I cut the train and only 15 wagons left.
But train stopped again.
3 ES44 with 15 wagon could not negotiate Cajon pass.
Is it real?

[derekmorton]

What version of OR?
Have you checked what power is in each loco?
Were you wheel slipping?
For ANY problem you need to post the OR log so we can get some of that information.

[mg123]

-

What version of OR? : 1.3
Have you checked what power is in each loco? : Full power
Were you wheel slipping? : Devore MP 71.0

[derekmorton]

For ANY problem you need to post the OR log so we can get some of that information.

[mg123]

Thanks for information,
Here it is.

[derekmorton]

Can you zip and post the 3 eng files please?

[mg123]

ES44DC 2(7517) and C44-9W 1(4400)

[geepster775]

I noticed your log shows you were restoring from a save. Did you attempt a run at the hill from a genuine fresh start? When the train stalls, if you zoom in on the locomotive bearing end caps, do you see them turning?

[derekmorton]

I have just run the activity up the hill and it ran as expected.

Can you post the consist please, I did notice that you have changed the engines.

[mg123]

Here is original consist.
But only a few wagons left.

[derekmorton]

That is 3 x dash9's and 60 cars, but you had more.

I am not surprised you could not get up the hill.

Run the default consist and see what you get.