Lots of errors?

[trainmanaustin]

I had an issue with an activity on OR Seligman that seemed to correct itself after the latest update but I triggered a log file before finding this out. I looked through the log and it still seems like there is quite a few errors in the log. Anyone have any advice or if I should even worry about them? I tried to attach the log file but it says that it is too large for the site.

[derekmorton]

Zip it and try again.

[trainmanaustin]

OpenRailsLog.zip

[trainmanaustin]

Zip it and try again.

Done

Sent from my SM-G900R4 using Tapatalk

[R. Steele]

Looking at the log, I'm seeing two problem areas:
1. The path string found in the OpenRails folder to the common.inc folder may be wrong. Check the placement of the common.inc folder, should appear in trainset alongside both the Common.cab and Common.Snd folder.

...and log entry

Information: Invalid passing path defined for train 34 at section 827 : overlaps with other passing path

I found quite a few of these, looks like the team at TS did not check for errors in the log...or they would have spotted them.
I had to go through an activity I wanted to run with the trackviewer and see how the paths and passing paths were laid out and made corrections where necessary. IMO ---- this was preventable before release...but hey, I'll give them some slack, since we're all trying to learn a new simulator here. In CN Ruel these overlapping errors are not so common...so looks like they learned from the mistake.

[trainmanaustin]

Looking at the log, I'm seeing two problem areas:
1. The path string found in the OpenRails folder to the common.inc folder may be wrong. Check the placement of the common.inc folder, should appear in trainset alongside both the Common.cab and Common.Snd folder.

...and log entry
I found quite a few of these, looks like the team at TS did not check for errors in the log...or they would have spotted them.
I had to go through an activity I wanted to run with the trackviewer and see how the paths and passing paths were laid out and made corrections where necessary. IMO ---- this was preventable before release...but hey, I'll give them some slack, since we're all trying to learn a new simulator here. In CN Ruel these overlapping errors are not so common...so looks like they learned from the mistake.

The Common.inc folder is in the trainset folder. I do not have a Common.cab folder and I have not transferred my Common.snd folder over from my MSTS Trainset folder. I have the TS Seligman installed in a separate folder.

[R. Steele]

Okay, couple of screenshots, with everything set up as you see it...the path string in the OpenRails folder is thus:

include ( "..\\..\\Common.inc\\Locomotives\\Std_Eng_D9-44CW_186-852t.inc" )

as seen in the last pic. Not knowing exactly how you have everything set up I cannot really answer the question...and my way is certainly not the only method...so you'll have to do a little investigating. Here's the pixs

bandicam 2019-10-03 20-46-01-280.jpg bandicam 2019-10-03 20-49-24-810.jpg bandicam 2019-10-03 20-49-54-961.jpg