CTC problem when passing red signal
Hello I was using the route of Cajon Pass 3 that is in MSTS downloads routes, but when passing a signal in red the emergency brakes of the locomotive are activated and I can not move the locomotive
-
Last edited by LuFeDuTi; 02-19-2019, 11:48.
Fostoria Stop Truck In A Level Crossing Please No Stop In Rail -
I assume you got permission before passing that signal, and got 'Permission granted' back when you did? If not, why are you passing a Stop signal? Unless you're passing a Stop and Proceed signal without stopping? That might trigger a penalty stop -
Throttle at zero
Reverser in neutral
Shift + / will initialize the brakes.
If brakes will still not reset. press Ctrl + M to go manual mode
then Shift + / followed by another Ctrl = M to toggle manual mode off and activity mode on.
Now you should ve able to move.
This is covered in the Open Rails Manual here: http://www.openrails.org/learn/manual-and-tutorials/
............Vince ..............
...... Author NECv4 .......
.... LIRR BUILD PHOTOS ....
...... Eschew Obsfucation ......
On the The Statue of Liberty in New York Harbor there is a Tablet. On it is written:
"Give me your tired, your poor, your huddled masses yearning to breathe free,
the wretched refuse of your teeming shore, send these, the homeless, tempest-tossed to me,
I lift my lamp beside the golden door!"Comment
Comment