Timetable mode: have a train jump to another location automatically before $forming

[markyisri]

I want my train to automatically move to another location (without needing to drive it there) and then $form into the next train.

Is this possible?

[roeter]

I suppose you mean the train ends at location A, and then you want to form it into another train which starts at location B?
Ofcourse you can form the train into another train at A which then runs to B, where it forms into the third train which is the train starting from B. You can select this third train as player train to drive it.
Obviously, what you cannot do is terminate the train at A, end then have it started as another train from B.
Trains cannot vanish at one location and then reappear at a different location.
It's also not possible to leave the train at A, then wait until it reaches B and there rejoin it.
So, you cannot run the train to A and then again from B within the same session, but you can do it as two separate sessions.

Regards,
Rob Roeterdink

[markyisri]

I suppose you mean the train ends at location A, and then you want to form it into another train which starts at location B?
Ofcourse you can form the train into another train at A which then runs to B, where it forms into the third train which is the train starting from B. You can select this third train as player train to drive it.
Obviously, what you cannot do is terminate the train at A, end then have it started as another train from B.
Trains cannot vanish at one location and then reappear at a different location.
It's also not possible to leave the train at A, then wait until it reaches B and there rejoin it.
So, you cannot run the train to A and then again from B within the same session, but you can do it as two separate sessions.

Regards,
Rob Roeterdink

Hi Rob,

I see. Is this a possibility to be added in the future?