I do not know if this is an OR problem, route problem or my video card. OR version X3095
Activity. running on Wisconsin Central (Reedsburg). Activity created by me. Short path as I run in manual anyway. Start at Merrimac going towards Baraboo. Enter Badger sub with two engines, 10 cars. Proceed to Army Ammo storage area. Do some pickups in Badger east, setting them out at Badger East 1 and 2. Continue in reverse with original 10 car consist, backing down to Badger West. Want to do a set out at Badger west 8. Still in reverse so rolling stock will be backed into B8. Just prior to reaching Badger 8 the display goes crazy with the consist suddenly accelerating very quickly, then stopping with the engines now in Badger 7 against the bumper, and no track in the forward view. Rear view has the track, rear is still on the track but well past the B8 switch. I can now back out of B7 at which time the front view clears and shows the track again. I can now pull forward of the B8 switch, throw it and back in with no problem. This is a consistent problem in OR at this part.
This activity does not do this in MSTS, only in OR.
Computer specs:
DELL STUDIO XPS 9100
INTEL I7-920 PROCESSOR
W7 PRO
12 GB TRICHANNEL DDR3SD RAM AT 1333 MH
ATI RADIONHD5670 1GB GDDR5
1 TB SATA
2 TB SATA
SOUNDBLASTER
Activity. running on Wisconsin Central (Reedsburg). Activity created by me. Short path as I run in manual anyway. Start at Merrimac going towards Baraboo. Enter Badger sub with two engines, 10 cars. Proceed to Army Ammo storage area. Do some pickups in Badger east, setting them out at Badger East 1 and 2. Continue in reverse with original 10 car consist, backing down to Badger West. Want to do a set out at Badger west 8. Still in reverse so rolling stock will be backed into B8. Just prior to reaching Badger 8 the display goes crazy with the consist suddenly accelerating very quickly, then stopping with the engines now in Badger 7 against the bumper, and no track in the forward view. Rear view has the track, rear is still on the track but well past the B8 switch. I can now back out of B7 at which time the front view clears and shows the track again. I can now pull forward of the B8 switch, throw it and back in with no problem. This is a consistent problem in OR at this part.
This activity does not do this in MSTS, only in OR.
Computer specs:
DELL STUDIO XPS 9100
INTEL I7-920 PROCESSOR
W7 PRO
12 GB TRICHANNEL DDR3SD RAM AT 1333 MH
ATI RADIONHD5670 1GB GDDR5
1 TB SATA
2 TB SATA
SOUNDBLASTER





Comment