Cabview errors

[crstagg]

What is causing ORTS to report these errors? I have included the lines and those before them below.

Warning: Ignoring additional positional parameters in C:\MSTS\trains\trainset\3DTrains_WP_Zephyr\CABVIEW \3DTrains_v4FUnit.cvf:line 78

Warning: Ignoring additional positional parameters in C:\MSTS\trains\trainset\3DTrains_WP_Zephyr\CABVIEW \3DTrains_v4FUnit.cvf:line 99

Here they are from 3DTrains_v4FUnit.cvf:
Lines 76-78
Lever (
Type ( THROTTLE LEVER )
Position ( 130 304 283 108 60 )

Lines 87-99
TriState (
Type ( DIRECTION TRI_STATE )
Position ( 162 422 416 144 58 )

[lindsayts]

What is causing ORTS to report these errors? I have included the lines and those before them below.

Warning: Ignoring additional positional parameters in C:\MSTS\trains\trainset\3DTrains_WP_Zephyr\CABVIEW \3DTrains_v4FUnit.cvf:line 78

Warning: Ignoring additional positional parameters in C:\MSTS\trains\trainset\3DTrains_WP_Zephyr\CABVIEW \3DTrains_v4FUnit.cvf:line 99

Here they are from 3DTrains_v4FUnit.cvf:
Lines 76-78
Lever (
Type ( THROTTLE LEVER )
Position ( 130 304 283 108 60 )

Lines 87-99
TriState (
Type ( DIRECTION TRI_STATE )
Position ( 162 422 416 144 58 )

The possible reason is that as far as I know "Position" only takes 4 arguments. The first two being the X Y coordinates of the graphic the second 2 being the size of the graphic as in the following......

TriState (
Type ( DIRECTION TRI_STATE )
Position ( 531 386 72 27 )
Graphic ( "..\\..\\GP38\\CABVIEW\\reverser.ace" )
NumFrames ( 3 1 3 )
Style ( NONE )
MouseControl ( 1 )
Orientation ( 0 )
DirIncrease ( 1 )

Cabview coordinate for the whole cabview is 640x480. In the above case the graphics is 531 units from the left edge and 386 units from the top, the size of the graphic "reverser.ace" being 72 wide by 27 high.
The reference point (0 point for both coordinates) for the graphics is the top left edge.

Lindsay

[Bananarama]

Yes, I believe the middle values can be dropped - I'm not 100% certain, however, as it's been several years since tinkering with the sets.

[crstagg]

Yes, I believe the middle values can be dropped - I'm not 100% certain, however, as it's been several years since tinkering with the sets.

Yes the Middle Value can be dropped. I edited them out and tested with MSTS. No error. And also ORTS no longer records an error.