what are the ato controls for the 1967 victoria line stock?
-
-
RE: ato controls
From the Readme
SACHA:
ATO instructions
To start the train, us the up arrow key to put the train in the forward
position, and when the doors have closed use the 'Z' key to increase the
power to 3 and wait for the train to move.
When the train has stopped at the next station, you will need to reduce the
power to 0 using the
'A' key, then press the 'Page up' key, then the 'Page Down' key, then the
'Z' key to increase the
power to 3 again when the doors have closed, and wait for the train to start
again.
The ATO train will stop at the stations by itself just by the marker points.
PAUL:
The following points have manual control, governed to 15mph by the ATO
system.
Brixton to Kings Cross route, at the end of the sidings after Kings Cross
station. Start the train manually and stop it at the siding end manually.
Kings Cross to Victoria, once you have left the sidings under manual control
and entered Kings Cross station, you will need to stop the train manually by
the stop marker point, and also at the end of the sidings after Victoria
Station (just the same as at Kings Cross sidings),
Victoria to Seven Sisters, then onto Northumberland Park Depot, once you
have left the sidings manually and entered Victoria Station, you will need
to stop the train manually by the stop marker point. Also once you have
arrived at Northumberland Park depot, the train will switch to manual, for
you to stop at the visible stop point.
You still need to press page up and page down at these points to reset the
ATO before moving away on manual.
Comment